E-Mail (SMTP) Enable and Setting

The E-mail function helps you send notifications or access passwords to users. E-mails are sent using the SMTP.

Set the function in Settings > Configuration > E-Mail card.

  1. When the E-mail function is switched on, a dialog box will open for you to set the following parameters:

    • SMTP Server Address, to which e-mails shall be sent.

    • Server Port, preset to 25.

    • Username and Password to the SMTP server account in case the SMTP server requires authorization.

    • Default Sender Address, from which e-mails shall be sent.

  2. Switch on if necessary:

    • SSL for e-mail encryption;

    • SSL Server Certificate verification;

    • Legacy Mode in the case of connection to older SMTP servers that do not support new functions (GSSAPI).

  3. After saving, you can set Base address for e-mail links, which will be part of the sent e-mails and refer to a selected part of the Access Commander interface, on the E-Mail card.

  4. Send a test e-mail to check the settings.

Can we advise you on anything else?

Take advantage of our technical support and sales specialists.

Contact Support

Contact Sales