You can view and administer device information in the device detail. Click the selected device list item to open the device detail. According to the device type, the detail can be divided into Overview, Calls and Lift.
Click the Configure hardware button in the right-hand upper corner of the device detail to move from the device detail to the web configuration. Refer to the Configuration Manual of the selected device for its configuration. Click the cross in the blue upper bar to quit the configuration web interface and return.
This card shows the state of connection with a device. Online devices are such devices that are connected with Access Commander and equipped with the acceptable firmware. Data synchronization can take place thanks to the established connection with the device. If incompatible, firmware can be allowed in Devices > Firmware.
Automatic synchronization is started upon every change that is to be reflected in the end device configuration. Synchronization only takes place over the devices that it relates to. Only the synchronization requests caused by the changes that can affect the end devices are queued. Such changes include changes of access rights, phone numbers, time profiles, etc. For example, a name change for the user that is not assigned to any group never starts automatic synchronization. The synchronization time (necessary for all the changes to be applied to end devices) depends on the count of devices to be synchronized and the amount of data to be uploaded into the device.
Set the zone to which the device is to be assigned.
If the device has 2 access points set up and if access point detection is enabled (see Setting Device Access Points), the option to assign 2 zones is displayed. One device access point can only be in one zone.
The card shows the current firmware version, MAC address and IP address and enables you to change the web configuration access password.
This card shows images from the device cameras and provides remote opening of the door switch controlled by this device. Click 
to open an advanced menu to set door opening for a certain period of time.
The current door switch state is displayed next to the button.
Use Emergency Lockdown to lock the door even for groups with valid access.
Backup helps you back up the device configuration in an xml file. Start the backup using . The last backup is displayed on the card from which the backup file can be downloaded. You can synchronize the device automatically with the last backup using the menu in . In this menu, you can synchronize the device with a backup stored on another device.
|
Note |
|---|---|
|
All the available devices (online devices and connected devices with incompatible firmware) can be backed up. |
Can we advise you on anything else?
Take advantage of our technical support and sales specialists.