Power Supply

Power supply must comply with PS1 class output.

You can feed 2N Indoor View as follows:

Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernet switch/router.
Using a 12 V / 1 A DC power adapter connected to the backside terminal board.

2N Indoor View Consumption Table:

Supply type	Consumption	Polarity reversal protection
PoE, IEEE 802.3af	12 W	✓
12 V DC ±10 % adapter; 1 A (recommended)	12 W	✓

Warning

Do not connect any external power supply if PoE is used and vice versa.
Connection of a defective or improper power supply may lead to a temporary or permanent device failure.
If you use a power adapter other than the recommended one, do not exceed the 12 V rated supply voltage. Also check the supply voltage polarity. Higher voltage values or misconnections may result in an irreplaceable device damage.

	Caution
	Make sure that the external power supply meets the power supply class PS2/LPS.

Use a standard straight RJ-45 terminated cable to connect 2N Indoor View to the Ethernet. The device supports the 10BaseT and 100BaseT protocols.

	Caution
	Factory reset results in a change of the Ethernet interface configuration. A defective Ethernet cable may lead to a high packet loss in the Ethernet and subsequent instability and poor call quality.

Figure 1. Ethernet cable connector	Figure 2. Ethernet socket
Tx Tx Rx unused unused Rx unused unused

	Warning
	This device cannot be connected directly to telecom lines (or public wireless networks) of any telecom service providers (i.e. mobile providers, landline providers or Internet providers). A router has to be used for the device Internet connection.

Can we advise you on anything else?

Take advantage of our technical support and sales specialists.