2N Indoor View is connected to the LAN and has to be assigned a valid IP address or obtain the IP address from the LAN DCHP server. The Network section helps you configure the IP address and DHCP.
|
Tip |
|---|---|
|
To retrieve the IP address, use 2N Network Scanner, which can be downloaded freely from 2N.com. Refer to Subs. IP Address Retrieval Using 2N Network Scanner for details. |
If the network uses the RADIUS server and 802.1x-based verification of connected equipment, you can make the intercom use the EAP-MD5 or EAP-TLS authentication. Set this function in 802.1x.
|
Note |
|---|---|
|
You can also make basic network settings in Settings > Advanced settings on the device. |
Use DHCP server – enable automatic obtaining of the IP address from the LAN DHCP server. If no DHCP server is existing or available in the network, set the network manually.
Static IP Address – static IP address of the device. The address is used together with the below mentioned parameters if the Use DHCP Server parameter is disabled.
Network Mask – network mask setting.
Default Gateway – default gateway address for off-LAN communication.
Always Use Manual Setting – enable manual setting of the DNS server addresses.
Primary DNS – primary DNS address for domain name-to-IP address translation.
Secondary DNS – secondary DNS address where the primary DNS is unavailable.
Hostname – set the device LAN identification.
Vendor Class Identifier – set the manufacturer identifier as a character string for DHCP Option 60.
VLAN Enabled – enable the virtual network support (VLAN according to 802.1q). Remember to set the VLAN ID too.
VLAN ID – choose a VLAN ID from the range of 1–4094. The device shall only receive packets with the set ID. An incorrect setting may result in a connection loss and subsequent factory reset.
Required Port Mode – set the LAN port mode to be preferred: Automatic or Half Duplex – 10 Mbps. The bit rate is reduced to 10 Mbps in case the available LAN cabling is unreliable for a 100 Mbps traffic.
Offered Modes – select the modes to be advertised in autonegotiation.
Current Port State – current LAN port state: Half or Full Duplex – 10 Mbps or 100 Mbps.
Authentication enabled – enable network device authentication via the 802.1x EAP-MD5 protocol. If the network does not support 802.1x, the intercom will become unavailable.
Password – enter the access password for EAP-MD5 authentication.
Authentication enabled – enable network device authentication via the 802.1x EAP-MD5 protocol. If the network does not support 802.1x, the intercom will become unavailable.
Trusted Certificate – specify the set of trusted certificates for verification of the RADIUS server public certificate validity. Choose one of three certificate sets, see Certificates. If no trusted certificate is included, the RADIUS public certificate is not verified.
Client certificate – specify the user certificate and private key for verification of the intercom authorization to communicate via the 802.1x-secured network element port in the LAN. There are three sets of user certificates and private keys, refer to the Certificates subsection, see Certificates.
Authentication Allowed – enable authentication of network devices via the 802.1x PEAP MSCHAPv2 protocol. If the network does not support 802.1x, the intercom will become unavailable.
Trusted Certificate – specify the set of trusted certificates for verification of the RADIUS server public certificate validity. Choose one of three certificate sets, see Certificates. If no trusted certificate is included, the RADIUS public certificate is not verified.
Password – enter the access password for PEAP-MSCHAPv2 authentication.
Can we advise you on anything else?
Take advantage of our technical support and sales specialists.