Where software configuration is unavailable, make basic settings using the RESET button (refer to 1).
The RESET button helps you reset the factory default values, restart the device, retrieve the device IP address and switch the IP address static/dynamic mode.
Press the button shortly (< 1 s) to restart the system without changing configuration.
Follow the instructions below to retrieve the current IP address:
-
Press and hold the RESET button.
-
Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard
(approx. 15–35 s). -
Release the RESET button.
-
The device announces the current IP address via the speaker automatically.
|
|
Note |
|---|---|
|
The delay after pressing RESET till the first light and sound signaling is set to 15–35 s depending on the device model used. |
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
-
Press and hold the RESET button.
-
Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard
(approx. 15–35 s). -
Wait until the red LED goes off and the acoustic signal can be heard
(approx. for another 3 s). -
Release the RESET button.
|
|
Note |
|---|---|
|
The following network parameters will be set after restart:
|
Follow the instructions below to switch on the Static IP address mode (DCHP ON):
-
Press and hold the RESET button.
-
Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard
(approx. 15–35 s). -
Wait until the red LED goes off and the acoustic signal can be heard
(approx. for another 3 s). -
Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s). -
Release the RESET button.
Follow the instructions below 2N Indoor View to reset the factory default values:
-
Press and hold the RESET button.
-
Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard
(approx. 15–35 s). -
Wait until the red LED goes off and the acoustic signal can be heard
(approx. for another 3 s). -
Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s). -
Wait until the red LED goes off and the acoustic signal can be heard
(approx. for another 3 s). -
Release the RESET button.
Can we advise you on anything else?
Take advantage of our technical support and sales specialists.