2N Indoor View is equipped with a real time clock without power outage backup. Select Use Time from Internet to synchronize the device time with the Internet time or click Synchronize with Browser to synchronize time with your current PC time.
|
Note |
|---|---|
|
The device does not need the current date and time values for its basic function. The current date and time values are necessary for a proper function of the time profiles and correct event times in some lists (Syslog, Entered cards, Log downloaded via HTTP API, etc.). |
|
Caution |
|---|---|
|
It is recommended that the Use time from Internet function is enabled for a maximum accuracy and reliability. The device time error can be up to ±2 minutes per month under normal operation conditions. |
Use time from Internet – Enable the NTP server use for device time synchronization.
– click the button to synchronize the device time with your current PC time value.
Automatic Detection – define whether the time zone shall be detected automatically from My2N. In case automatic detection is disabled, the Manual selection parameter is Used (manually selected time zone or Own rule).
Detected Time Zone Display – the automatically found time zone. In case the function is unavailable or disabled, N/A is displayed.
Manual Selection – set the time zone for your installation site. to define time shifts and summer/winter time transitions.
Custom Rule – if the device is installed on a site that it not included in the Time Zone parameter, set the time zone rule manually. The rule is applied only if the Time Zone parameter is set to Manual.
NTP Server Address – set the IP address/domain name of the NTP server used for the device internal time synchronization. The server IP address and domain name cannot be set if Use Time from Internet is disabled.
NTP Time Status – display the state of the last local time synchronization attempt via NTP: Unsynchronized. Synchronized, Error.
Can we advise you on anything else?
Take advantage of our technical support and sales specialists.